upgraded from 1.11 to 1.19 and running rich now.

[tricura]

Looking for some update to this thread???

I have run into the same problem, I need to upgrade from 1.11 to 1.19. When I convert the file it says everything goes well, I update the firmware to EMS it says it's done. When I try to fire the car back up it is overly rich and will not start. I can can go back down and everything is fine.

I have looked at some of the pointers in this thread and all mine match and seem to be the same. I am tuned on a boost comp map now and do not want to start over (what an AEM tech told me to do). Is there a way to look for something other then do the map comparison (which I did) to make the car run on a 1.19 converted file?

Thanks for your time.

[turbo97se]

I did this a long time ago. I think the thing that got messed up was the MAP sensor setting (in the Wizards). Just go in and check your MAP sensor is still set correctly. I may be wrong, but it won't hurt to check this.

[Thiefcode]

I did this a long time ago. I think the thing that got messed up was the MAP sensor setting (in the Wizards). Just go in and check your MAP sensor is still set correctly. I may be wrong, but it won't hurt to check this.

j

This turned out to be my problem, too.  The O2 sensor cal tables were not transferred properly, and the compare feature caught this error.