This is how you will connect the 0-5v analog output wire from the Gauge Type UEGO Controller (30-4100) or Single/Dual Channel Wideband Controll (30-2301/2300) to the AEM EMS.
AEM EMS P/N LAMBDA #1 PIN LAMBDA #2 PIN
30-1000/1001/1002/1040/1042 D14 D16
30-1010/1012/1050/1052 C16 A23
30-1020/1060 D7 D14
30-1030/1070 A6 E2
30-1080 C16 C8
30-1100/1101 B47 B48
30-1110 1C 9C
30-1120/1121/1130 B6 B14
30-1300 4 66
30-1310/1311/1312/1313 76 75
30-1320 71 73
30-1400 29 43
30-1401 44 43
30-1510 C2-31 C2-33
30-1600/1601/1602/1603 19
30-1610/1611/1612 46
30-1620/1621/1622/1623 29 55
30-1710 2N 4J
30-1720 C3 D3
30-1800 C3 A2
30-1810 D19 B17
30-1820/1821 A26 D25
If your AFR between the gauge and software is way off, then most likely, your AFR unit is not correct in AEMPro. The AFR unit defaults at AFR methanol even it shows AFR gasoline. In AEMPro, go to "Configure" > "Units" select AFR unit, select AFR gasoline (if you're already on AFR gasoline, select something else, hit apply, and select AFR gasoline again).
great info!
