V0.80 -> Bug? - LS8 output V1.19 (Rad fan & A/C fan)

[Vitor]

Compared to Pro 1.0, in V1.19 you can set LS8 output for a/c and rad fan.

When importing a CAL from Pro 1.0 to 0.80, it prompts you to select one:



V

[shaundrake]

I get that with the old AEMTuner also (.2.4). I have a 30-1000 box.

[Vitor]

Same output pin conflicts on version 0.80

Bug? Undocumented feature ? 

[AZ]

this is related to the output config, so it will be solved when the new output config is ready.

[AZ]

Updated:

This is NOT a bug. in AEM Pro, you can set one pin to multiple outputs, but actually there will be conflict on that pin. The correct way is: a pin can only be assigned to one output.

AEMTuner can detect this problem.

[Vitor]

This contradicts the conversion notes, unless I am misreading it:

7. The A/C control function was revised in V1.19.
* Go to Setup | Air Conditioner | Options – A/C.
** If you want to activate your radiator fan when the air conditioner is turned on, configure you’re A/C options as follows:
** Find the low speed radiator fan output as defined in your applications pin-out sheet and use this output to define both the A/C Fan Speed and Rad Fan options as shown below.
** You must also turn off the low speed fan control LSX_Alt option.
For example, if your low speed is defined as LS8, go to Options | Full List and turn option LS8_Alt OFF. IF you don’t do this, the output will cycle when the A/C function is ON.

Page 6 of V1.19 Conversion Notes PDF

Please clarify.