March 21, 2010, 08:44:34 AM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: AEM ECU Jumper/Extension Harnesses! Available NOW!!
 
Pages: [1]
« previous next »
Print
Author Topic: Is map switching supported or not?  (Read 909 times)
WhatsADSM
EMS Poster Child
*
Posts: 3
« on: June 08, 2009, 10:21:02 AM »
Basic premise is that I am trying to have a switch in the car which will allow me to fill up with 93 octane instead of E-85, and at least be able to have a reasonable tune on. (Effectively a retard in boost timing, and removing fuel).

From researching I have gotten mixed results. It appears that some people indicate that the feature does exist while others say it doesn't. What is the final say on this? I can't seem to find anything in AEM Pro that allows me to configure multiple maps.

BTW, Yes I have tried to use the N2O map for it however it didn't seem to work at all to be honest. The N2O trigger didn't see the switch I had wired in, and then when I turned it to "Switch always On" the N2O state would randomly toggle between On and Off even though all of the parameters were moved WAY out of the way and it should have always been on?!
Logged
akumay
Global Moderator
25+ Posts Club
*****
Posts: 94
« Reply #1 on: June 10, 2009, 06:23:31 AM »
nope, not supported.

but like u said, u can use the n20 maps, and yes it works, sounds like u dont have the options configured properly.
Logged
specialed
Short Bus Driver
Administrator
100+ Post Club
*****
Posts: 108
« Reply #2 on: June 23, 2009, 05:46:01 AM »
What model EMS do you have?
Logged
WhatsADSM
EMS Poster Child
*
Posts: 3
« Reply #3 on: July 13, 2009, 04:50:00 PM »
Quote from: specialed on June 23, 2009, 05:46:01 AM
What model EMS do you have?

It is for the Nissan RB26 I believe the part number is:
30-1621
Logged
AEM Performance Electronics Forum
   
 Logged
Pages: [1]
Print
« previous next »
Jump to: