March 19, 2010, 10:44:16 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: AEM ECU Jumper/Extension Harnesses! Available NOW!!
 
Pages: [1]
« previous next »
Print
Author Topic: AEM Water/Methanol Injection  (Read 995 times)
NS
Yum Yum Time
Administrator
300+ Post Club
*****
Posts: 324



WWW
« on: June 30, 2009, 12:36:11 PM »
Welcome to the new AEM Water/Methanol Injection forum section.  Information will be added shortly to help build this section into a helpful resource to those with both general water injection queries and AEM-specific questions.  We look forward to your participation.

Thanks.
Logged
Series 2 EMS Now Available For Hondas and Acuras!
Flateric
25+ Posts Club
*
Posts: 27
« Reply #1 on: December 05, 2009, 08:51:04 PM »
Ok, well here goes then. Can we get an offical opinion on where the nozzle should be place realtive to the AIT sensor?

It's a GM AIT probe and an AEM meth kit, on a big single 2jz situation, controlled by a series 2 ecu.

It's a topic of which there is wide and varied opinion on.

Thanks.
Logged
NS
Yum Yum Time
Administrator
300+ Post Club
*****
Posts: 324



WWW
« Reply #2 on: March 11, 2010, 01:18:15 PM »
Attached are the instructions for the 30-3000 Water/Methanol Injection kit.
* 10-3000 Water Injection Manual UPDATED 2009 12 1.pdf (323.7 KB - downloaded 12 times.)
Logged
Series 2 EMS Now Available For Hondas and Acuras!
AEM Performance Electronics Forum
   
 Logged
Pages: [1]
Print
« previous next »
Jump to: