March 18, 2010, 02:21:47 PM *
Welcome, Guest. Please login or register.
Did you miss your activation email?

Login with username, password and session length
News: AEM ECU Jumper/Extension Harnesses! Available NOW!!
 
Pages: [1]
« previous next »
Print
Author Topic: How to wire Tru Boost to EMS  (Read 285 times)
The Gravel Crew
EMS Poster Child
*
Posts: 3
« on: September 22, 2009, 12:31:04 PM »
I was talking to a potential tuner about either using my Tru Boost controller or use another aftermarket BCS.  The answer he gave me was to wire in the Tru Boost controller to the EMS?  Sounds logical but wanted to get some other opinions.  And if I go the route in using my Tru Boost Controller how do I go about wiring it into my EMS 30-1810.
Thanks everyone.
Logged
NS
Yum Yum Time
Administrator
300+ Post Club
*****
Posts: 319



WWW
« Reply #1 on: September 22, 2009, 02:11:28 PM »
When it comes to the EMS and Tru Boost it's usually one or the other and not both.  Most use the EMS to control boost because you have logging capability and it's a feedback system.  If you already have the Tru Boost system you can still use the gauge itself to display boost. 
Logged
Series 2 EMS Now Available For Hondas and Acuras!
The Gravel Crew
EMS Poster Child
*
Posts: 3
« Reply #2 on: September 22, 2009, 03:38:53 PM »
Thank you very much.
Logged
The Gravel Crew
EMS Poster Child
*
Posts: 3
« Reply #3 on: January 28, 2010, 11:50:26 PM »
I have installed a different BCS.  Now my TRU Boost controller has ERS error.  I just wanna use it as a guage.  What do I need to disconnect?
Thanks
Logged
NS
Yum Yum Time
Administrator
300+ Post Club
*****
Posts: 319



WWW
« Reply #4 on: January 29, 2010, 07:55:42 AM »
You need to change the run mode to OFF.  Press the left button for two seconds and then release to toggle between run modes.  When the run mode is set to off the gauge isn't trying to detect the solenoid and you won't get the error any more.
Logged
Series 2 EMS Now Available For Hondas and Acuras!
AEM Performance Electronics Forum
   
 Logged
Pages: [1]
Print
« previous next »
Jump to: