5bar MAP sensor and boost solenoid

[hmrn4gater15]

i have the sensor hooked to the factory wiring, but what vac line do u run to the end of 5bar sensor? Also, with the boost solenoid, does anyone have a pic to where the pw2 pin is that u wire it to. does the wiring go to the stock wiring harness or the aem wiring harness? thanks a lot guys

[Jakencub]

Which map sensor and boost solenoid are you using?  The dodge factory map sensor should plug into the stock location on the top of the intake manifold. If you are using the AEM 5bar map sensor, best bet is to make or buy an adapter to repace the factory map sensor.  then you can use the stock wiring for the hook up. 


This is what i did.  I also made a small aluminum adapter plate with a 1/4 NPT threaded hole for the AEM 5bar with an o-ring to seal it to the Intake Manifold.



I also used a GM boost solenoid, I can look for the number for you later, but that also used the factory wiring.  works great.



Jake