O2 FB & Wizard bug with v.99b

[jonbar87]

I am now using aemtuner on a series 1 box and it seems to be working great except for a few things....for some reason there is no "O2 FB Min Load" option in the parameters. Also, the "O2 FB Max Load", "O2 FB Min RPM" and "O2 FB Max RPM" channels do not transfer over, although they can be added. (sometimes it says N/A beside them though....?) Also, the fuel trim "Fuel vs. Idle RPM" table says "This table is not available in current calibration"

those are the only bugs I've run into so far.

*edit* just found another bug. when I go to wizards>setup wizards, it says that there is "No wizard found for this calibration version"

[SB]

First off, thanks for the feedback.



There are literally thousands of options, tables, and maps in every EMS calibration.  Each of them have unique names, and both AEMPro and AEMTuner open them based on these names.

Many of the options, tables and maps have been renamed in the Series 2 EMS. For instance, we felt it would be better for people to simply type "Coil 1"  to select that output from an options or channels list, rather than having to use the shift key and find which number is used for the blasted '#' sign to type in 'Coil #1.' On the original ECUs, there is a table called "Air Temp Fuel Corr", I'm pretty sure the Corr stands for Correction as opposed to Correlation but "Air Temp Fuel Trim" makes more sense and uses fewer characters. Throttle Fuel Trim, Boost Fuel Trim, and Baro Fuel Trim are a few other examples of names that have been updated... the current workspace for AEMTuner has been configured to use both the old (Series 1) and new (Series 2) names for most tables and options, but there are probably a few we haven't covered. The options you've mentioned aren't being opened because they don't exist (using that name) in the old calibrations. O2 FB Min Load didn't exist in the Series 1 calibrations, the others are there with different names. You can add the options by using add/remove options... the 2D tables (fuel vs idle) will require an updated workspace from AEM, look for that to be included in the next release of AEMTuner.


For the time being we're focusing on improving the interface primarily as it relates to the new Series 2 units, but as these sort of things are pointed out we'll try to improve the support for the old units where possible.

Hope this helps,
SB

[jonbar87]

makes sense. Thanks!

what about the lack of wizards?

[AZ]

wizard is using name as reference too, so a Series 2 wizard won't work on Series 1 calibration.