Hooking up temp sensors to the EMS

[Vitor]

On the 30-1900 box, to use a ECT (engine coolant temp) sensor into spare inputs (in the oil pan), I would think I would need to replace the pull up resistor from 100K to 2.2K.

Easier to just use temp sensor from one of the digital serial gauges?

V

[JKOBD]

So I have a 1060 box and I am trying to install a secondary IAT sensor.  My primary Honda IAT has been replaced as well.  I have the GM sensor just prior to the TB, but also have a IAT just prior to the IC.  Is there any way to run a secondary air temp sensor on the 1060 box?

[Vitor]

Do you have spare 0-5v input ?

If so, add in right push up resistor of a 5v source and you have your secondary temp input, which of course will show in amepro as voltage, not a temperature, but to wich you can add a math function and convert to temperature in log software (wish this was available in aem pro as well!)